DSTM Installation

To Install DSTM, one needs to perform the system installation which includes the application of an RPC patch from the ENST website and then commencing with the installation of DSTM system modules. To install DSTM system modules the source code should be unpacked and after going to dstmd directory, the 'make system' and 'make systeminstall' commands should be executed to compile the system modules.

Note that the website mentioned above explains the installation procedure in more detail.

After system installation one needs to configure the DSTM server/TEP and the DSTM clients as follows:

Configuration of the DSTM server/TEP

In this example the following lines where the output from the command "ifconfig" before starting on the configuration of the DSTM server: